Notícias e comunicados à imprensa

Liebherr mobile cranes launch 100-tonne motor ship into water

LTM 1350-6.1 and LTM 1400-7.1 mobile cranes launch ship's hull with a weight of 100 tonnes into water in tandem hoist

Liebherr mobile cranes launch 100-tonne motor ship into water

The “Seegold” is a new motor ship for shuttle services on Lake Constance. In May two Liebherr mobile cranes have launched the 100-tonne ship's hull into the water. Tight spaces and the low capacity of the quay in Friedrichshafen made the lift a challenge. In use were an LTM 1350-6.1 from the Wiesbauer company, and an LTM 1400-7.1 from Paule.

LTM 1300-6.2 mobile crane with Liebherr single-engine concept proves itself in use

Several dozen models of this new crane have since proven their worth on sites around the world.

LTM 1300-6.2 mobile crane with Liebherr single-engine concept proves itself in use

Liebherr unveiled the new 300-tonne LTM 1300-6.2 at the Bauma 2013, featuring a brand new power concept to operate the superstructure. Instead of the twin-engine concept normally used on cranes in this class this crane is powered by a single engine with a mechanical shaft. Gear shafts are routed from the distributor gear in the substructure via two mitre gears through the centre of the slewing ring to the pump distributor gear in the superstructure. Several dozen models of this new crane have since proven their worth on sites around the world.

Liebherr telescopic handler TL 432-7 at the Maskin Expo 2015: new model with 7 m lifting height

At the Maskin Expo 2015, Liebherr showcases the TL 432-7, a representative of the new telescopic handler model range with 7 m lifting height. Three models with 7 m lifting height are available. During development, demands from companies in the construction industry and equipment hire were at the forefront.

Liebherr crawler excavator R 914 Compact at the Maskin Expo 2015

At the 2015 Maskin Expo, Liebherr is presenting the crawler excavator R 914 Compact, which supplements the product program of compact crawler excavators. The compact excavator was first presented at the 2013 Bauma in Munich (Germany). The design of this 15 tonne machine features the same concept as the A 914 Compact and A 918 Compact wheeled excavators.

Liebherr LTF 1060-4.1 truck-chassis crane provides maximum load capacity of 60 tons

At the 2015 Maskin Expo, Liebherr displays the LTF 1060-4.1 truck-chassis crane with a maximum load capacity of 60 metric tons. This crane was first launched in 2009 as an addition to the top end of the cranes intended for installation on truck chassis. With a 40-metre telescopic boom and a 16 m double folding fly jib, this crane can lift loads to a height of up to 56 m and an outreach of 48 m.

Liebherr LH 22 M Material Handling Machine at the 2015 Maskin Expo

The machine exhibited in Stockholm at the 2015 Maskin Expo is an excellent representative from the Liebherr range of small material handlers. The LH 22 is available with both wheeled and crawler undercarriage.

2015 Maskin Expo: Enhanced comfort for operators with Liebherr wheel loaders

Liebherr is exhibiting the wheel loaders L 538 and L 580 at the 2015 Maskin Expo. Both machines are equipped with kinematics that are suitable for industrial applications. The L 538 is a real all-rounder – even the organizer of the 2015 Maskin Expo uses this Liebherr wheel loader for setting up the fairgrounds. The modern cabin design and a broad range of sophisticated equipment, such as the additional heating at the L 580, enhance comfort for the operator. Due to the hydrostatic driveline, both exhibits are very fuel efficient, consuming up to 25 percent less fuel.

The Liebherr A 910 Compact Wheeled Excavator: Compact and Powerful

Liebherr is going to present the A 910 Compact at the 2015 Maskin Expo. This additional model in the series of compact wheeled excavators was debuted at the 2013 Bauma. The design of this 11.8 tonne machine is based on the same concept as the two A 914 Compact and A 918 Compact wheeled excavators, which have already achieved market success.

Liebherr apprentices gain professional experience in Norway

Apprentices of Liebherr-Verzahntechnik GmbH became acquainted with Norwegian companies, as well as the people and culture of the country, in a four-week exchange programme.

Liebherr tower crane enables a completely pre-assembled rotor to be installed

World premiere - The largest Liebherr tower crane model the 1000 EC-B 125 Litronic made it possible to lift a completely pre-assembled rotor, with a diameter of 113m, for a new wind turbine in Deining, Bavaria. The flat-top crane with a hook height of 155.5 m hoisted the assembly weighing almost 70 tonnes to a height of 142.5 m.

Customer days of Liebherr Nenzing 2015: Viking Cranes choses two Liebherr crawler cranes

The Estonian crane rental company Viking Cranes has for the first time opted for Liebherr crawler cranes.

Elcon Crane Hire adds Liebherr LTM 1400-7.1 mobile crane to its fleet

South African crane contractor Elcon Crane Hire recently took delivery of a Liebherr LTM 1400-7.1 mobile crane. The 400-tonne model on a 7-axle chassis is a major expansion upwards for the crane fleet. Previously an LTM 1250-6.1 with a load capacity of 250 tonnes was the company's most powerful crane.

Liebherr mobile cranes fit out luxury liner at a tense night job

Two Liebherr LTM 1750-9.1 mobile cranes complete giant cruise ship at Papenburger Meyer shipyard.

Tense night job for Gertzen – Liebherr mobile cranes fit out luxury liner at Papenburger Meyer shipyard

At the end of February in North Germany the "Anthem of the Seas", the largest cruise ship ever built in Germany was moved out of the massive Hall 2 dock at Papenburger Meyer shipyard. It was only possible to install the funnel casing and "North Star" viewing gondola outdoors due to the sheer size of the vessel. The order for this work was awarded to Gertzen, based in nearby Kluse, which completed the job smoothly using two 750-tonne mobile cranes. Gertzen used the Liebherr LTM 1750-9.1 from its own fleet and an LTM 1750-9.1 hired from Thömen.

New Generation Diesel Engines for Liebherr Mobile Harbour Cranes

In order to meet the required emission and fuel consumption targets, Liebherr enhanced the diesel engines for its mobile harbour crane (LHM) fleet.

New Generation Diesel Engines for Liebherr Mobile Harbour Cranes

The enhanced Liebherr diesel engines for mobile harbour cranes meet the stage IV and Tier 4 final emission standards and reduce fuel consumption.