Liebherr tower crane works on unusual bridge construction

It’s the first job of its kind in Germany: the 125 EC-B 6 tower crane is mounted on a platform attached to the side of the new bridge. It stands on a moveable unit that advances with the bridge as construction progresses.

A hook height of 16 metres is enough

The Liebherr 125 EC-B 6 tower crane has an important role to play in the project. It doesn't need to be its maximum size for this job though: a hook height of 16.5 metres and a jib length of 42.5 metres are enough. The flat-top crane can actually reach a hook height of up to 59 metres and a radius of up to 58 metres. But for this project, the crane is mounted at around the same height as the top edge of the bridge; extending 16 metres upwards above the bridge is sufficient.

The tower crane is ably supported by three Liebherr 81 K.1 fast-erecting cranes, which are being used for general work on site and can lift up to 6 tonnes. These cranes achieve a maximum radius of 48 metres and a maximum hook height of 40.4 metres. An additional Liebherr crane may join them as construction progresses: a mobile construction crane from the LTM series.

The crane is being supplied by Hüffermann Krandienst GmbH, based in Wildeshausen near Bremen. The full service provider in the field of crane and heavy-duty logistics is relying on the expertise of Liebherr Tower Crane Solutions for this particular job. The project department for special assignments has been on hand from the outset to advise on the crane platform for the moveable scaffolding system. The flat-top crane has been contracted by leading Swiss construction services provider Implenia.

Construction site needs to be kept as small as possible

The Elbe landscape surrounding the bridge is a nature conservation area, which means that all those involved have to meet special requirements. This can be seen from the construction method, which uses a moveable scaffolding system due to the need for the construction site to operate in as little space as possible. The bridge is being divided into four segments, which will be assembled on land. The individual sections will then be pushed across the Elbe one by one to their respective support piers, a process that is expected to start in early 2024. The final bridge section will be transported across the Elbe on a floating pontoon. The crane has been in Wittenberge since September 2023 to help with preparations and is scheduled to be on site for a full year.

9,000 tonnes of steel are to be used for the bridge, which is around 2,000 tonnes more than was needed for the Eiffel Tower. The separate bridge sections are made up of individual 20 metre-long components that are manufactured in Saxony.

Expansion of the A 14 motorway in full swing

The motorway currently ends at Magdeburg and starts again at Schwerin. As part of the northern extension of the A 14 motorway, traffic will in future be able to cross the Elbe via a bridge measuring approx. 1,100 metres in length; the longest bridge of the entire motorway extension northwards. One end of the bridge will stand near Wittenberge, Brandenburg, the other near Seehausen in Saxony-Anhalt. It is due to open in 2026 but won't yet be part of the motorway at that time, as the surrounding motorway sections won’t have been completed by then. The approximately 155-kilometre-long new section is currently the largest new motorway construction project in Germany and is expected to be completely open to traffic from 2028